Axis double programmed, Start position incorrect, Touch point inaccessible – HEIDENHAIN TNC 415 (259 9x0) Service Manual User Manual
Page 91: Range exceeded, Cycl parameter incorrect, Plane wrongly defined, Time limit exceeded
SERVICE MANUAL TNC 415B/425
Page 86
Issue: 20.08.95
RANGE EXCEEDED
- The range has been exceeded during probing, i.e. a part of the 3D-contour is outside the range.
CYCL PARAMETER INCORRECT
- The programmed travel or the distance between lines or points is negative or larger than 56 535 mm.
(only possible with Q-parameter programming)
TOUCH POINT INACCESSIBLE
- The stylus was deflected before the range was reached during approach.
- In the cycle CONTOUR LINES, the stylus was not deflected within the probing range.
STYLUS ALREADY IN CONTACT
- The stylus is not at rest, although it is not touching the contour.
PLANE WRONGLY DEFINED
- One of the coordinates of the starting point in the cycle CONTOUR LINES is identical with the touch
probe axis.
START POSITION INCORRECT
- The starting point coordinate that is identical with the starting probe-axis is beyond the range.
AXIS DOUBLE PROGRAMMED
- The same axis has been programmed for both starting point coordinates in the cycle CONTOUR LINES.
TIME LIMIT EXCEEDED
- In the scanning cycle CONTOUR LINES the first point of the scanned line was not reached within the
programmed time limit.
STYLUS DEFLECTION EXCEEDS MAX.
- The stylus was deflected by more than the value programmed in the machine parameter MP6330 (TM110).