HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 228)

Tapping
Function MP
No. Bit
A B C Input AE-6
Entry value
Minimum feed override when
tapping 7110.0 Š Š Š 0 to 150 [%] 95
Maximum feed override when
tapping 7110.1 Š Š Š 0 to 150 [% ] 105
Dwell time for change of direction
of spindle rotation in a tapping
cycle
7120.0 Š Š Š 0 to 65.535 [s] 0
Spindle run-on time in a tapping
cycle (only effective with BCD output of
the spindle speed)
7120.1 Š Š Š 0 to 65.535 [s] 0
Spindle slow-down time after
reaching the boring depth
7120.2 Š Š Š 0 to 65.535 [s] 0
Tapping without floating tap holder
•
run-in behaviour of the spindle 7130 Š Š Š 0.001 to 10 [°/min] 0.5
•
transient response of the spindle
during acceleration 7140 Š Š - 0.01 to 0.999 0.15
Positioning window for tool axis
7150 Š Š Š 0.0001 to 2 [mm] 0.05
Oriented spindle stop at the
beginning of cycle 17 "Rigid
Tapping"
7160 Š Š Š 0 = spindle orientation is executed
1 = spindle orientation is not executed
1
R H
1.0 TNC
415B/425/426 Machine Parameters MP 7110.0 - MP 7160 03.01.95 5.2 50