HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 7)

SERVICE MANUAL TNC 415B/425
Page 4
Issue: 20.08.95
2. Minor Error Messages
TNC 415B/425 features a comprehensive integral monitoring system to avoid input and operation errors,
to locate errors and technical defects of the entire equipment (TNC, measuring systems, machine tool,
cables etc.). The monitoring system is a fixed component of the TNC hardware and software; it is always
active when the control is switched on. If a technical defect or an operation error is detected, an error
message in plain language is displayed on the screen.
To erase minor error messages, press
CE
.
Further error messages are described in the
•
Operating Manual TNC 407/415B/425
•
Technical Manual TNC 407/415/425
•
Documentation by the machine tool manufacturer
•
Operating Instructions FE 401 B.
Error Message Sec. Error Message Sec.
AXIS DOUBLE PROGRAMMED 15.2 ERR: 102 16.3
START POSITION INCORRECT 15.2 ERR: 103 16.3
TOUCH POINT INACCESSIBLE 15.2 ERR: 104 16.3
RANGE EXCEEDED 15.2 ERR: 105 16.3
OPERATING PARAMETERS ERASED 2.1 ERR: 106 16.3
BAUD RATE NOT POSSIBLE 16.3 ERR: 107 16.3
CYCL PARAMETER INCORRECT 15.2 ERR: 108 16.3
FAULTY RANGE DATA 15.2 ERR: 109 16.3
ROTATION NOT PERMITTED 15.2 PROGRAM DATA ERRONEOUS 16.3
DATA MEDIUM MISSING 16.3 WRONG OPERATING MODE 16.3
DATA MEDIUM EMPTY 16.3 WRONG AXIS PROGRAMMED 15.2
DATA MEDIUM WRITE-PROTECTED 16.3 HANDWHEEL ? 14.3
LIMIT SWITCH 2.1 HANDWHEEL DEFECTIVE 14.3
PLANE WRONGLY DEFINED 15.2 ME: TAPE END 16.3
EMERGENCY STOP 19.6 SCALING FACTOR NOT PERMITTED 15.2
EXT. IN-/OUTPUT NOT READY 16.3 PLC PROGRAM NOT TRANSLATED 2.1
ERR: 001 16.3 PLC: ERROR <00 to 99> 2.1
ERR: 002 16.3 POSITIONING ERROR 2.1
ERR: 003 16.3 PROGRAM INCOMPLETE 16.3
ERR: 004 16.3 POWER INTERRUPTED 2.1
ERR: 005 16.3 INTERFACE ALREADY ASSIGNED 16.3
ERR: 006 16.3 RELAY EXT. DC VOLTAGE MISSING 19.6
ERR: 007 16.3 STYLUS ALREADY IN CONTACT 15.2
ERR: 010 16.3 PROBE SYSTEM NOT READY 15.2
ERR: 011 16.3 EXCHANGE TOUCH PROBE BATTERY 15.2
ERR: 012 16.3 TRANSFERRED VALUE ERRONEOUS X 16.3
ERR: 013 16.3 TRANSFERRED DATA INCORRECT X 16.3
ERR: 014 16.3 TIME LIMIT EXCEEDED 15.2
ERR: 015 16.3
ERR: 016 16.3
ERR: 017 16.3
ERR: 018 16.3
ERR: 100 16.3
ERR: 101 16.3