How to use this service manual – HEIDENHAIN TNC 415 (259 9x0) Service Manual User Manual
Page 6
SERVICE MANUAL TNC 415B/425
Page 3
Issue: 20.08.95
1. How to Use this Service Manual
The service manual TNC 415B/425 can be used to diagnose, locate and eliminate errors on machine
tools controlled by TNC.
In order to correctly judge the problems in an NC-controlled machine tool, fundamental knowledge of the
machine tool and its drives as well as their interaction with the control and the measuring systems is required.
Incorrect behaviour of the machine tool can also result from improper use of the control, NC-programming
errors and incorrect or not properly optimized machine parameters.
For further information in this respect please refer to the
•
Documentation of the machine tool manufacturer
•
Operating Manual (HEIDENHAIN)
•
Technical Manual (HEIDENHAIN).
The Technical Manual is not enclosed with every control. In general, it is only supplied to the machine tool
manufacturer and is updated by HEIDENHAIN, Traunreut. Therefore, it is absolutely necessary to contact the
machine tool manufacturer, if errors occur that are due to a machine parameter or to the interface of the
control. Support will, however, also be provided by the HEIDENHAIN service department and agencies.
Telephone numbers, addresses and telex/fax numbers can be found on the back side of the cover page and
the back side of the service manual.