HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 251)

Function MP
No. Bit
A B C Input AE-6
Entry value
Parameter with multiple
function
•
Memory function for axis
direction keys
7680
0 Š Š 0 = not stored
+1 = stored
%00011111
•
Re-approaching the contour 1 Š Š 0 = inactive
+2 = active
•
Block scan 2 Š Š 0 = inactive
+4 = active
•
Interruption of block scan by
"STOP" or by M06 3 Š Š 0 = interruption
+8 = no interruption
•
Include dwell time during block
scan to change the direction of
rotation in a "tapping" cycle 4 Š Š 0 = dwell time is waited to end
+16 = dwell time is not waited to end
•
Start calculation with block scan 5 Š Š 0 = start from cursor position
+32 = start from beginning of program
•
Tool length for blocks with surface
normal vector 6 - Š 0 = without DR2 from the tool table
+64 = with DR2 from the tool table
•
Bit reserved 7 - -
R H
1.0 TNC
415B/425 Machine Parameters MP 7680 08.05.95 5.2 73