HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 224)

Function MP
No. Bit
A B C Input AE-6
Entry value
Deflection depth of stylus 6300 1) 10 - - 0.1 to 2.0000 [mm] 1
Deflection depth of stylus 6310 - Š Š 0.1 to 2.0000 [mm] 1
Counting direction of the encoders
in the touch probe
X
Y
Z
6320
0
1
2
10 10 Š 0 = positive
+1 = X axis negative
+2 = Y axis negative
+4 = Z axis negative
0
Calculating the center offset when
calibrating the TM 110 6321 - Š Š 0 = calibrate and measure center offset
1 = calibrate without measuring center offset 0
Allocation of the touch probe axes
to the machine axes
machine axis
machine axis
machine axis X
Y
Z
6322.0
6322.1
6322.2 -
-
- Š
Š
Š
Š
Š
Š
0 = touch probe axis X
1 = touch probe axis Y
2 = touch probe axis Z 0
1
2
Maximum deflection of the stylus 6330 10 10 Š 0.1 to 4 [mm] 3
Minimum deflection of the stylus 6340 I12 I12 - 0.001 to 0.5 [mm] 0.005
Feed rate for positioning to the MIN
point and contour approach 6350 10 Š Š 10 to 3 000 [mm/min] 300
Feed rate for probing in measuring
cycles 6360 10 Š Š 10 to 3 000 [mm/min] 1000
Rapid traverse for probing 6361 10 Š Š 10 to 10 000 [mm/min] 2000
Feed rate reduction
if the stylus (TM 110) is deflected away
from its path 6362 - Š Š 0 = feed reduction inactive
1 = feed reduction active 0
1) with special software and for TNC 426 this function has been shifted to MP 6310!
R H
1.0 TNC
415B/425/426 Machine Parameters MP 6300 - MP 6362 06.03.95 5.2 46