HEIDENHAIN TNC 415 (259 9x0) Service Manual User Manual

Page 176

Code Numbers

123

MACHINE PARAMETER EDITING FOR END USERS (marked by *)

75368

OFFSET ADJUSTMENT

79513

VOLTAGE AND TEMPERATURE DISPLAY

86357

REMOVE EDIT/ERASE PROTECTION

95148

MP MODE

105296

COMPENSATION VALUE LIST

531210

RESET M 1000 TO M 2000 AND BYTES 0 - 127

620159

DOWNLOAD RUN-IN PROGRAM VIA INTERFACE

807667

PLC MODE

688379

INTERNAL OSCILLOSCOPE

951026

START RUN-IN PROGRAM FROM EPROM

Machine Parameters

In the following list the machine parameters for all software versions are listed.
Since however, certain machine parameters are only valid for a certain software version, or are only active from a certain software version on,
columns with symbols for differentiation have been introduced after the machine parameter number.

Explanation of the Symbols:

= The machine parameter applies for all software versions of this control.

= The machine parameter has been introduced with a certain software version (e.g. 04 means: introduced with software version 04).

I04 = The machine parameter is inactive.
-

= The machine parameter is not available with this control.

Explanation of the Columns:

= TNC 415B/F/BR/FR and TNC 425/E with NC software 259 93* -- or 259 94*

= TNC 415B/F/BR/FR and TNC 425/E with NC software 280 54* -- or 280 56* -- (special software)

= reserved

AE6

= entry values for operation with HEIDENHAIN test unit

RH
1.0 TNC