Westermo GDW-11 - Manual (Page 269)

TCP SOCKET AUTOCONNECT Commands 269 6615-2220
AT*WTCPSTOP – Deactivates a TCP session
Description:
This command deactivates a TCP session previously activated with AT*WTCPSTART.
After closing the an TCP session, the modem will still have the GPRS active.
The AT*WTCPI=1 command gives more detailed information about the commands
execution status.
Syntax:
AT*WTCPSTOP
Command example Possible responses Note
+++ OK Enter command mode with
the escape sequence.
AT*WTCPSTOP OK Close the TCP session.
AT*WIPSTATUS – GPRS & TCP connect status information
Description:
This command reports IP stack status and current local IP.
Reported event for IP stack are:
– NO_SERVICE
– IDLE
– CONNECTED
– DIALING
Syntax:
AT*WIPSTATUS
Parameters:
–
Command example Possible responses Note
AT*WIPSTATUS IP stack state: “IDLE” Check status:
Current local IP: none PDP context is not active
AT*WGPRSCONNECT OK Activate PDP context
AT*WIPSTATUS IP stack state: “CONNECTED” Check status:
Current local IP: 192.168.25.46 PDP context is now active
and unit has received an IP-
address