Westermo GDW-11 - Manual (Page 220)

220 GPRS commands 6615-2220
+CGQMIN – Quality of Service Profile (Minimum acceptable)
Description:
This command allows the TE to specify a minimum acceptable profile which is checked
by the MT against the negotiated profile returned in the Activate PDP Context Accept
message.
The set command specifies a profile for the context identified by the local context
identification parameter, . Since this is the same parameter that is used in the
+CGDCONT command, the +CGQMIN command is an extension to the +CGDCONT
command. The QoS profile consists of a number of parameters, each of which may be set
to a separate value.
A special form of the set command, +CGQMIN= causes the minimum acceptable
profile for context number to become undefined. In this case no check is made
against the negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports
several PDP types, the parameter value ranges for each PDP type are returned on a
separate line.
Syntax:
AT+CGQMIN=[ [, [, [, [, [,]]]]]]
Response Syntax:
AT+CGQMIN?
+CGQMIN: , , , , ,
[+CGQMIN: , , , , , [. . .]]
AT+CGQMIN=?
+CGQMIN: , (list of supported s), (list of supported s),
(list of supported s) , (list of supported s), (list of supported
s)
[+CGQMIN: , (list of supported s), (list of supported
s), (list of supported s) , (list of supported s), (list of sup-
ported s) [. . .]]
Parameters:
A numeric parameter which specifies a particular PDP context.
A numeric parameter which specifies the precedence class.
A numeric parameter which specifies the delay class.
A numeric parameter which specifies the reliability class.