Westermo GDW-11 - Manual (Page 250)

250 I/O commands – only in GDW-12 6615-2220
OUT: Phone number of the modem where the output shall be set. If , is
empty the transfer will be to the local digital output.
CMD: AT command string to be executed when the entry is trigged, can be used
to modify the trigger condition
TRANS: Phone number of the modem to which the transparent I/O should occur.
For dependencies of other parameters and line type, Please See Table 1
… =number
Makes a connection to the number defined and start Transparent I/O
transfer between the two units.
… =empty
Transparent I/O transfer will use an existing data connection.
Interpretation of field is also service dependent the size is 0 – 160 characters.
DIAL: Not used
SMS: The SMS message
TEXT: Text message
EMAIL: E-mail message
OUT: A sequence of “101.. “ to be transferred to the addressed output
CMD: Not used
TRANS: Not used
Field is only used for SMS and EMAIL service.
The content of in each service is described below.
SMS: SMS provider number.
EMAIL: Reserved for ISP number
Field is only used for SMS and EMAIL service.
The content of in each service is described below.
SMS: SMS protocol. 0 = No protocol, 1= UDP, 2 = TAP
EMAIL: Reserved for email protocol
Field is only used for SMS and EMAIL service.
The content of in each service is described below.
SMS: Password for access to SMS provider
EMAIL: Reserved for password to mail server
Field is only used for EMAIL service. The content of is described below.
EMAIL: Reserved for username to mail server