Westermo GDW-11 - Manual (Page 216)

216 GPRS commands 6615-2220
+CGQREQ – Requested Quality of Service Profile
Description:
This command allows the TE to specify a Quality of Service Profile that is used when the
MT sends an Activate PDP Context Request message to the network.
The command specifies a profile for the context identified by the local context identifica-
tion parameter, . Since this is the same parameter that is used in the +CGDCONT
command, the +CGQREQ command is effectively an extension to the +CGDCONT
command. The QoS profile consists of a number of parameters, each of which may be set
to a separate value.
A special form of the command, +CGQREQ= causes the requested profile for
context number to become undefined.
The command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports
several PDP types, the parameter value ranges for each PDP type are returned on a
separate line.
Syntax:
AT+CGQREQ=[ [, [, [, [, [,]]]]]]
Response Syntax:
AT+CGQREQ?
+CGQREQ: , , , , ,
[+CGQREQ: , , , , ,
[. . .]]
AT+CGQREQ=?
+CGQREQ: , (list of supported s), (list of supported s),
(list of supported s) , (list of supported s), (list of supported
s)
[+CGQREQ: , (list of supported s), (list of supported
s), (list of supported s) , (list of supported s), (list of sup-
ported s) [. . .]]
Parameters:
Numeric parameter that specifies a particular PDP context definition.
Range of values is 1 to 3