Westermo GDW-11 - Manual (Page 161)

V.24-V.25 commands 161 6615-2220
Command example Possible responses Note
AT+IPR? +IPR: 9600 Current rate is 9600 bit/s
OK
AT+IPR=? +IPR: (0, 2400, 4800, 9600, Possible values, according
19200, 38400, 57600), (300, 600, to V25 ter
1200, 115200) Recommendation: the first
OK set of values indicates the
range of auto-detectable
baud rates (including 0).
The second set of values
indicates the baud rates
supported by the DCE
but not auto-detectable.
AT+IPR=38400 OK Disable autobauding and
set rate to 38400 bit/s
AT+IPR=0 OK Enable autobauding