Westermo GDW-11 - Manual (Page 175)

Specific AT commands 175 6615-2220
No value: Last value used for a CCED request, or 15
… If parameter is not provided, the one of the last +CCED com-
mand will be used, or 15 (default value).
… Values of MCC/MNC are set to 0 in the case of “No service”.
Command example Possible responses Note
AT+CCED=0 +CCED:208,20,0002,0418, last request was
37,706,24,,,0,,,0, 208,20,0006, AT+CCED=0,3 (main cell
989b,37,835,20,208,20,0002, and neighbors 1 to 6): you
02a9, 37,831,12,208,20,0101, can see MCC,MNC
7966,34,818,13,208,20, sequences (here 208,20)
0006,9899,39,713,9,208,20,
0002,0a72,33,711,
12,208,20,
0101,03fb,36,824,10,1
OK
AT+CCED=0,1 +CCED:208,20,0002,0418,37, Only Main cell request
706,25,,,0,,,0
OK
AT+CCED=0,1 +CCED:208,10,189C,,19,85,, Call in progress: RXLev
31,32,,0,0, and RXQual are empty,
OK RxLevFull, RxLevSub,
RxQualFull and
RxQualSub have data