Westermo GDW-11 - Manual (Page 244)

244 GPRS commands 6615-2220
Parameters:
A numeric parameter which specifies a WESTERMO GPRS parameter.
0: ATTACH-STATUS (the ME don’t make automatically a GPRS attachment after init)
1: PDP-INIT-STATUS (declare some PDP contexts liable to be activated automatically
after initialization by =2)
2: Set ACTIVABLE automatically after init a define PDP context
3: PPP silent mode
4: definition of the GPRS multislot class.
5: Slow CONNECT for PALM® OS
6: PPP Filtering
NOTE:
… If =0, 1, 3, 4, 5 or 6, and values will be ignored.
… If =0, 1, 2, 3, 5 or 6, value will be ignored.
… If =4, and values will be ignored.the modem must be
restarted to take the modification into account.
… PPP Filtering is a test-purpose functionality. It avoids sending on the radio link some
OS-specific frames, for accurate transfer rate measurements.
A numeric parameter that controls the operation defined by if it is equal to 0,
1, 2 or 3.
0: operation OFF (disabled)
1: operation ON (enabled)
(PDP Context Identifier) a numeric parameter which specifies a particular PDP context
definition. The parameter is local to the TE-MT interface and is used in other PDP
context-related commands. Range of values is 0 to 4.
GPRS multislot class number. It may be lower than the maximum possible class. Possible
values are 2, 8, 10, 12. Refer to doc ref [6] for more information about GPRS multislot
classes.