Westermo GDW-11 - Manual (Page 177)

Specific AT commands 177 6615-2220
Parameters:
0: no unsolicited “+WIND: ” will occur (default value)
1 (bit 0): Hardware SIM Insert / Remove indications or SIM presence after soft-
ware reset
2 (bit 1): Calling party alert indication
4 (bit 2): Product is ready to process AT commands (except phonebooks, AOC,
SMS), but still in emergency mode.
8 (bit 3): the product is ready to process all AT commands, at the end of init or
after swapping to ADN in case of FDN configuration
16 (bit 4): a new call identifier has been created (after an ATD command, +CCWA
indication)
32 (bit 5): network or other party has released an active, held or waiting call
64 (bit 6): Network service available indication
128 (bit 7): Network lost indication
256 (bit 8): Audio ON indication
512 (bit 9): SIM Phonebooks reload status
1024 (bit 10): SIM phonebooks checksum indication
2048 (bit 11): Interruption indication (only if FTR_INT is activated)
4096 (bit 12): Hardware Rack Open/Closed Indication
8192 (bit 13): NITZ indication
Combination (addition of the values) is used to allow more than one indication flow: 0
IndLevel
≤ 16383
The response is OK if the values are in the previous range.
The supported events are:
0: The SIM presence pin has been detected as “SIM removed”
1: The SIM presence pin has been detected as “SIM inserted”
2: Calling party is alerting
3: Product is ready to process AT commands (except phonebooks, AOC, SMS), at init
or after AT+CFUN=1
4: Product is ready to process all AT commands, end of phonebook init or swap (FDN
to ADN)
5: Call has been created (after ATD or +CCWA…)
6: Call has been released, after a NO CARRIER, a +CSSU: 5 indication, or after
the release of a call waiting
7: The network service is available for an emergency call.
8: The network is lost.
9: Audio ON.
10: Show reload status of each SIM phonebook after init phase (after Power-ON or SIM
insertion).