Westermo GDW-11 - Manual (Page 139)

Data commands 139 6615-2220
+ILRR – DTE-DCE local rate reporting
Description:
This parameter controls whether the extended-format “+ILRR: ” information text
is transmitted from the DCE to the DTE or not. The value reported represents
the current (negotiated or renegotiated) DTE-DCE speed rate.
If enabled, the intermediate result code is transmitted in an incoming or outgoing data
call, after any data compression report, and before any final result code (CONNECT).
Syntax:
AT+ILRR =
Parameters:
0: disable local port rate report
1: enable local port rate report
Can take the following values: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200 (kbit/s).
Command example Possible responses Note
AT+ILRR=0 OK Local port rate report
disabled
AT+ILRR=1 OK Local port rate report
enabled
AT+ILRR? +ILRR: 1 Current value
OK
AT+ILRR=? +ILRR: (0,1) Possible values
OK