Westermo GDW-11 - Manual (Page 170)

170 V.24-V.25 commands 6615-2220
&V – Display configuration
Description:
This command is used to display the modem configuration.
Syntax:
AT&V
Result Syntax:
The parameters displayed are the following:
Q, V, S0, S2, S3, S4, S5,
+CR, +CRC, +CMEE, +CBST,
+SPEAKER, +ECHO, &C, &D, %C
+IPR, +ICF, +IFC9
Parameters:
0: Display the modem configuration in RAM. (default value if no parameter provided)
1: Display the modem configuration in EEPROM.
2: Display the modem factory configuration.
Command example Possible responses Note
AT&V Q:0 V:1 S0:000 S2:043 Display active parameters
S3:013 S4:010 S5:008 in RAM
+CR:0 +CRC:0 +CMEE:0
+CBST:0,0,1
+SPEAKER:0
+ECHO:0,0
&C:1 &D:2 %C:0
+IPR:9600 +ICF:3,4 +IFC:2,2
OK