Westermo GDW-11 - Manual (Page 25)

Call Control commands 25 6615-2220
Verbose result code Numeric code Description
with ATV0 set
OK 0 If the call succeeds, for
voice call only
CONNECT 10,11,12, 13,14,15 If the call succeeds, for data
calls only, takes
the value negotiated by the
product
BUSY 7 If the called party is already
in communication
NO ANSWER 8 If no hang up is detected
after a fixed network time-
out
NO CARRIER 3 Call setup failed or remote
user release. Use the
AT+CEER command to find
out the failure cause
Parameters:
is the number to dial.
(optional parameter)
“I” – “invocation” (restrict CLI presentation)
“i” – “suppression” (allow CLI presentation)
Phonebook (one of “SM”, “LD”, “MC”, “ME”, “RC”, “MT” or “SN”). A default value can be
selected by +CPBS command.
call number at indicated offset from the phonebook selected by the +CPBS command
call number corresponding to given name from the phonebook selected by the +CPBS
command.
Command example Possible responses Note
AT+CPBS? +CPBS:”SM”,8,10 ADN phonebook is select-
ed, 8 locations are used and
10 locations are available
ATD>SM6; OK Call index 6 from AND
phonebook and call suc-
ceeds
Command specific information
When the FDN phonebook has been locked, only numbers beginning with the digits
of FDN phonebook entries can be called. For example, if “014629” is entered in the FDN
phonebook all the phone numbers beginning with these 6 digits can be called.