Westermo GDW-11 - Manual (Page 19)

General commands 19 6615-2220
+CRSM – Restricted SIM access
Description:
By using this command instead of Generic SIM Access +CSIM TE application has easier
but more limited access to the SIM database. This command transmits to the MT the SIM
and its required parameters.
As response to the command, MT sends the actual SIM information parameters and
response data. MT error result code +CME ERROR may be returned when the command
cannot be passed to the SIM, but failure in the execution of the command in the SIM is
reported in and parameters.
As for the CSIM command, there is no locking between two successive commands. The user
should be aware of the precedence of the GSM application commands to the TE commands.
Syntax:
AT +CRSM=[[,,[]]]
Response:
+CRSM:,[]
+CME ERROR:
Parameters:
Integer type.
Command passed on by the MT to the SIM; refer GSM 11.11 (or 3GPP TS 51.011):
176: READ BINARY
178: READ RECORD
192: GET RESPONSE
242: STATUS
all other values are reserved and the command will return
+CME ERROR=3
NOTE 1:
The MT internally executes all commands necessary for selecting the desired file, before
performing the actual command.
Integer type.
This is the identifier of a elementary datafile on SIM. Mandatory for every command
except STATUS.
NOTE 2:
The range of valid file identifiers depends on the actual SIM and is defined in GSM 11.11
(or 3GPP TS 51.011). Optional files may not be present at all. This value must be in the
range [0 – 65535] else a CME_ERROR=3 is returned.
, , Integer type.
Parameters passed on by the MT to the SIM. These parameters are mandatory for every
command, except GET RESPONSE and STATUS. The values are described in GSM 11.11
(or 3GPP TS 51.011).