Westermo GDW-11 - Manual (Page 165)

V.24-V.25 commands 165 6615-2220
&D – Set DTR signal
Description:
This commands controls the Data Terminal Ready (DTR) signal.
Syntax:
AT&D
Parameters:
0: The DTR signal is ignored
1: Modem switches from data to command mode when DTR switches from ON to
OFF
2: Upon DTR switch from ON to OFF, the call is released
Command example Possible responses Note
AT&D0 OK The DTR signal is ignored
AT&D1 OK Modem switches from data
to command mode when
DTR switches from ON to
OFF
AT&D2 OK Upon DTR switch from
ON to OFF, the call is
released
&S – Set DSR signal
Description:
This commands controls the Data Set Ready (DSR) signal.
Syntax:
AT&S
Parameters:
0: DSR always on
1: DSR off in command mode, DSR on in data mode
Command example Possible responses Note
AT&S0 OK DSR always on
AT&S1 OK DSR off in command mode,
DSR on in data mode