Westermo GDW-11 - Manual (Page 183)

Specific AT commands 183 6615-2220
+WDR – Data Rate
Description:
This command allows the data rate for bearer data to be configured for outgoing and
incoming calls.
Syntax:
AT+WDR=[,]
AT+WDR=[],
Response Syntax:
+WDR: ,
NOTE:
is related to outgoing calls, and to incoming calls.
Parameters:
0: FR
1:
HR, other supported types: FR
2: FR, other supported types: HR
0: HR
1: FR
Command example Possible responses Note
AT+WDR=? +WDR: (0-2),(0-1) If Half Rate available in
OK both directions
AT+WDR=? +WDR: (0),(1) If Half Rate not available.
OK
AT+WDR=1 OK Configure data type FR,
HR with HR preferred, for
outgoing calls (ing_type> parameter is
omitted)
AT+WDR=,1 OK Configure data type FR for
incoming calls (ing_type> parameter is
omitted)
AT+WDR=3 +CME ERROR: 3 Illegal value
AT+WDR? +WDR: 1,1 Ask for the current value
OK