Westermo GDW-11 - Manual (Page 248)

248 I/O commands – only in GDW-12 6615-2220
*WIOL – Generic I/O list
Description:
This command is used to program the list of I/O entries with parameters and data.
The list can contain up to 10 entries
Syntax:
Set up a service entry:
AT*WIOL= ,,,,,,,ata3>, ,,
NOTE:
List all table entries. Listing will pause ever 3.th entry and wait for any key hit to con-
tinue. ESC will terminate.
Parameters:
IO entry number, up to eight entries can be defined.
IO entry service, value as described in table below:
0: NONE, No service defined for this entry
1: DIAL, Makes a connection to the number defined in
2: SMS, data fields defined as described below:
Destination number of the SMS
SMS-message.
SMS service provider number
SMS protocol type (0=NONE,1=UCP,2=TAP)
Password if required by provider.
3: TEXT, Make a connection to number defined in and transfer text defined in
.
4: EMAIL, Reserved for future use, service not implemented
5: OUT, Make a connection to the number defined in and set/pulse the
remote output according to pattern defined in string defined in . The con-
nection is terminated after the pattern is transferred.
6: CMD, AT command specified by is executed when the entry is trigged
7: TRANS, Makes a connection to number defined by , I/O is transferred
transparently between the two units. The transparent mode must be ended by a
timeout.