Westermo GDW-11 User Manual
Page 174
174 Specific AT commands
6615-2220
NOTE:
… The response for the requested dump 1, 2 and 4 will be:
+CCED:
OK
where
and CI values which are in hexadecimal form) of the parameters. If a field cannot be
measured – or is meaningless – the parameter is not filled in, and two consecutive
commas are sent.
… The response for the requested dump 8 will be a +CSQ response and not a
+CCED response. The 07.07 format for +CSQ is respected. The
ated by this command, so the
+CSQ:
OK
When automatic shots are selected, this +CSQ response is sent every time the
mode and during communication. The activation or deactivation of this flow (8)
does not affect the other flows.
… In idle mode, only RxLev measurements (on the main cell and on the neighboring
cells) are made.
… Combination of the requested dump is supported (addition of the values 1, 2, 4
and 8):
1:
+CCED response: Main Cell only
2:
+CCED response: Neighbors 1 to 6
3:
+CCED response: Main Cell, then Neighbors 1 to 6
4: +CCED
response:
Timing
Advance
only
5:
+CCED response: Main Cell, then Timing Advance
6:
+CCED response: Neighbors 1 to 6, then Timing Advance
7:
+CCED response: Main Cell, then its Timing Advance, then Neighbors 1 to 6, with
each Timing Advance inserted between cells results
8:
+CSQ response: Main Cell RSSI indications
9:
+CSQ response, then +CCED response with Main Cell only
10: +CSQ response, then +CCED response with Neighbors 1 to 6
11: +CSQ response, then +CCED response with Main Cell, then Neighbors 1 to 6
12: +CSQ response, then +CCED response with Timing Advance only
13: +CSQ response, then +CCED response with Main Cell, then Timing Advance
14:
+CSQ response, then +CCED response with Neighbors 1 to 6, then Timing
Advance
15:
+CSQ response, then +CCED response with Main Cell, then its Timing Advance,
then Neighbors 1 to 6, with each Timing Advance inserted between cells results