Westermo GDW-11 - Manual (Page 176)

176 Specific AT commands 6615-2220
+WIND – General Indications
Description:
This command provides the user with a general mechanism to send unsolicited non-
standardized indications to the application. These indications are:
… indication of a physical change on the SIM detect pin from the connector (meaning
SIM inserted, SIM removed)
… indication during mobile originated call setup that the calling party is ringing.
… Indication of the availability of the product to receive AT commands after boot.
… NITZ indication (Network Information and Time Zone).
…
For each indication, a “bit flow” has to be indicated.
Syntax:
AT+WIND=
Result Syntax:
The AT+WIND? command is supported and indicates the .
AT+WIND settings are automatically stored in non volatile memory (EEPROM). This
means the &W command does not need to be used and the selected flows are always
activated after boot.
Default value is 0: no flow activated, no indication.
AT+WIND=? gives the possible value range (0-4095)
The unsolicited response will then be:
+WIND: [ , ]
Call identifier, defined in +CLCC command.
Or for event 10:
+WIND: ,,,…,,
Or for event 11:
+WIND: ,[“”],[“”],[“ON>”],[“”] ,[“”],[“LD>”]
Or for event 15 (NITZ indication):
+WIND: [,1,””][,2,””][,3,”zone>”][,4,””][,5,””][,
6,””]