Westermo GDW-11 - Manual (Page 162)

162 V.24-V.25 commands 6615-2220
+ICF – DTE-DCE character framing
Description:
This command is used to determine the local serial port start-stop (asynchronous) char-
acter framing used by the DCE.
Syntax:
AT+ICF= [, ]
Parameters:
0: Auto detect (not supported)
1: 8 Data 2 Stop (supported) parameter is ignored.
2: 8 Data 1 Parity 1 Stop (supported) if no provided, 3 is used by default as
value.
3: 8 Data 1 Stop (supported) parameter is ignored.
4: 7 Data 2 Stop (supported) parameter is ignored.
5: 7 Data 1 Parity 1 Stop (supported) if no provided, 3 is used by default as
value.
6: 7 Data 1 Stop (supported) parameter is ignored.
0: Odd (supported)
1: Even (supported)
2: Mark (supported)
3: Space (supported)
4: None (supported)
NOTE:
Setting a character framing different from 8N1 will disable autobauding if it was activated.
Setting it back to 8N1 will not re-enable auto-baud.
Setting the framing to 8N1 will let the autobauding enabled, if it was already enabled
(implying framing was already 8N1).
Command example Possible responses Note
AT+ICF? +ICF: 3,4 Current values
OK
AT+ICF=? +ICF: (1-6),(0-4) Possible values
OK
AT+ICF=2,0 OK Set 8 databits Odd parity
and 1 stop bit