Westermo GDW-11 - Manual (Page 13)

General commands 13 6615-2220
+CPAS – Modem activity status
Description:
This command returns the activity status of the mobile equipment.
Syntax:
AT+CPAS
Parameters:
0 ready (allow commands from TA/TE)
1 unavailable (does not allow commands)
2 unknown
3
ringing (ringer is active)
4 call in progress
5 asleep (low functionality)
Command example Possible responses Note
AT+CPAS +CPAS: Current activity status OK
+CMEE – Report Mobile Equipment errors
Description:
This command disables or enables the use of the “+CME ERROR : ” or
“+CMS ERROR :” result code instead of simply “ERROR”.
See chapter ”error codes” for ”+CME ERROR” result codes description and
”+CMS ERROR” result codes.
Syntax:
AT+CMEE=
Parameters:
0: Disable ME error reports, use only ”ERROR”
1: Enable long error reports, ”+CME ERROR xxx” or ”+CMS ERROR xxx”
Command example Possible responses Note
AT+CMEE=0 OK Disable ME error reports,
use only « ERROR »
AT+CMEE=1 OK Enable ”+CME ERROR:
” or ”+CMS ERROR:
” result codes
AT+CMEE=? +CMEE: (0,1) Possible values
OK
AT+CMEE? +CMEE: 1 Current value
OK