Cr – service reporting control – Westermo GDW-11 User Manual
Page 137

Data commands 137
6615-2220
+CR – Service reporting control
Description:
This command enables a detailed type of service reporting in the case of incoming or
outgoing data calls. Before sending the CONNECT response to the application, the prod-
uct will specify the type of data connection that has been set up.
These report types are:
+CR: ASYNC For asynchronous transparent
+CR: REL ASYNC For asynchronous non-transparent
Syntax:
AT+CR=
Parameters:
0:
disable extended reports
1:
enable extended reports
Command example
Possible responses
Note
AT+CR=0 OK
Extended
reports
disabled
AT+CR=1 OK
Extended
reports
enabled
AT+CR?
+CR: 1
Current value
OK
AT+CR=?
+CR: (0,1)
Possible values
OK
This manual is related to the following products: