Westermo GDW-11 - Manual (Page 267)

TCP SOCKET AUTOCONNECT Commands 267 6615-2220
AT*WTCPCLIENTIP – Configures the the IP address if the client
Description:
This command specifies the IP address of the remote client when the unit is configured
as a server and used in the TCP Autoconnect mode with the PING synchronisation ena-
bled (*WTCPPINGSYNC=1).
The server has to be configured with the IP address of the client since the servers
*WTCPSERV is set to work as an address-mask.
Syntax:
AT*WTCPCLIENTIP=
Parameters:
Client IP address.
Command example Possible responses Note
AT*WTCPCLIENTIP= OK Configures the IP address
”192.168.62.52” of the client
AT*WTCPCLIENTIP? *WTCPCLIENTIP: Current value
”192.168.62.52”
OK
AT*WTCPCLIENTIP=? *WTCPCLIENTIP: Valid parameters
(”remote client IP”)
OK
AT*WGPRSCONNECT – Initiates a GPRS PDP context
Description:
Initiates a GPRS PDP context activation according to the gprs parameters (see *WTCPV
for list of parameters).
The AT*WTCPI=1 command gives more detailed information about the commands
execution status.
Syntax:
AT*WGPRSCONNECT
Command example Possible responses Note
AT+CGREG? +CGREG: 0,1 Indicates that unit is
attached to GPRS network.
AT*WGPRSCONNECT OK Activate GPRS