Westermo GDW-11 - Manual (Page 260)

260 TCP SOCKET AUTOCONNECT Commands 6615-2220
TCP SOCKET AUTOCONNECT Commands
*WTCPCONNECT – TCP socket link control
Description:
This command is used to enable or disable the TCP socket link control. When enabled, the
modem will automatically after power on, set up connections to a packet switched network
and start working either as a TCP server or a client (depending on configuration).
Syntax:
AT*WTCPCONNECT=
Parameters:
1= enabled
0=disabled
Command example Possible responses Note
AT*WTCPCONNECT=1 OK Enable TCP link control
AT*WTCPCONNECT? *WTCPCONNECT: 1 Show value
OK
AT*WTCPCONNECT=? *WTCPCONNECT: (0,1) Show range
OK
*WTCPMODE – TCP client server select
Description:
This command is used to select if the modem shall act as a client or server in a TCP
socket link.
Syntax:
AT*WTCPMODE=
Parameters:
1= server
0=client
Command example Possible responses Note
AT*WTCPMODE =1 OK Set modem to work in
server mode
AT*WTCPMODE? *WTCPMODE: 1 Show value
OK
AT*WTCPMODE =? WTCPMODE: (0,1) Show range
OK