beautypg.com

Table 25: auto provision settings, Figure 60: auto provision settings – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 93

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 92 of 303

Figure 60: Auto Provision Settings

Table 25: Auto Provision Settings

Enable Zero Config

Enable or disable the zero config feature on the PBX. The default setting

is enabled.

Enable Automatic

Configuration Assignment

By default, this is disabled. If disabled, when SIP device boots up, the

UCM6100 will not send the SIP device the URL to download the config file

and therefore the SIP device will not be automatically provisioned by the

UCM6100.

Note:

When disabled, SIP devices can still be provisioned by manually sending

NOTIFY from the UCM6100 which will include the XML config file URL for

the SIP device to download.

Automatically Assign Extension

If enabled, when the device is discovered, the PBX will automatically

assign an extension within the range defined in "Zero Config Extension

Segment" to the device. The default setting is disabled.

Zero Config Extension

Segment

Click on the link "Zero Config Extension Segment" to specify the

extension range to be assigned if "Automatically Assign Extension" is

enabled. The default range is 5000-6299. Zero Config Extension

Segment range can be defined in web UI->PBX->Internal

Options->General page->Extension Preference section: "Auto Provision

Extensions".

Enable Pick Extension

If enabled, the extension list will be sent out to the device after receiving

This manual is related to the following products: