beautypg.com

Sip settings/tos, Table 90: sip settings/tos – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 264

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 263 of 303

SIP SETTINGS/TOS

Table 90: SIP Settings/ToS

ToS For SIP

Configure the Type of Service for SIP packets. The default setting is

None.

ToS For RTP Audio

Configure the Type of Service for RTP audio packets. The default setting

is None.

ToS For RTP Video

Configure the Type of Service for RTP video packets. The default setting

is None.

Default Incoming/Outgoing

Registration Time

Configure the default duration (in seconds) of incoming/outgoing

registration. The default setting is 120.

Max Registration/Subscription

Time

Configure the maximum duration (in seconds) of incoming registration

and subscription allowed by the UCM6100. The default setting is 3600.

Min Registration/Subscription

Time

Configure the minimum duration (in seconds) of incoming registration and

subscription allowed by the UCM6100. The default setting is 60.

Music On Hold Interpret

Configure the Music On Hold class for the channel when being put on

hold. This is used when the Music On Hold class is not set on the channel

and the peer channel placing the call on hold doesn't have "Music On

Hold Suggest".

Music On Hold Suggest

Configure the Music On Hold class to suggest to the peer channel when

placing the peer on hold.

Enable Relaxed DTMF

Select to enable relaxed DTMF handling. The default setting is "No".

DTMF Mode

Select DTMF mode to send DTMF. The default setting is RFC2833. If

"Info" is selected, SIP INFO message will be used. If "Inband" is selected,

64-kbit codec PCMU and PCMA are required. When "Auto" is selected,

"RFC2833" will be used if offered, otherwise "Inband" will be used. The

default setting is "RFC2833".

RTP Timeout

During an active call, if there is no RTP activity within the timeout (in

seconds), the call will be terminated. The default setting is no timeout.

Note:

This setting doesn't apply to calls on hold.

RTP Hold Timeout

When the call is on hold, if there is no RTP activity within the timeout (in

seconds), the call will be terminated. This value of RTP Hold Timeout

should be larger than RTP Timeout. The default setting is no timeout.

Trust Remote Party ID

Configure whether the Remote-Party-ID should be trusted. The default

setting is "No".

Send Remote Party ID

Configure whether the Remote-Party-ID should be sent or not. The

default setting is "No".

This manual is related to the following products: