beautypg.com

Device configuration, Create new device, Figure 67: upload model template manually – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 108: Device, Configuration

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 107 of 303

Figure 67: Upload Model Template Manually

DEVICE CONFIGURATION

On web GUI, page PBX->Zero Config->Zero Config, users could create new device, delete existing

device(s), make special configuration for a single device, or send NOTIFY to existing device(s).

CREATE NEW DEVICE

Besides configuring the device after the device is discovered, users could also directly create a new device

and configure basic settings before the device is discovered by the UCM6100. Once the device is plugged

in, it can then be discovered and provisioned. This gives the system administrator adequate time to set up

each device beforehand.

Click on "Create New Device" and the following dialog will show. Follow the steps below to create the

configurations for the new device.

1. Firstly select a model for the device to be created and enter its MAC address, IP address and firmware

version (optional) in the corresponding field.

2. Basic settings will show a list of settings based on the model selected in step 1. Users could assign

extensions to accounts, assign functions to Line Keys and Multiple-Purposed Keys if supported on the

selected model.

3. Click on “Create New Device” to save the configuration for this device.

This manual is related to the following products: