beautypg.com

Using extension groups – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 209

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 208 of 303

USING EXTENSION GROUPS

Here is an example where the extension group can be used. Go to Web GUI->PBX->Basic/Call

Routes->Outbound Routes and select "Enable Filter on Source Caller ID". Both single extensions and

extension groups will show up for users to select.

Figure 121: Select Extension Group in Outbound Route

This manual is related to the following products:
See also other documents in the category Grandstream Communication: