beautypg.com

Iax settings, Iax settings/general, Iax settings/registration – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 258: Table 82: iax settings/general, Table 83: iax settings/registration

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 257 of 303

IAX SETTINGS

The UCM6100 IAX global settings can be accessed via Web GUI->PBX->IAX Settings.

IAX SETTINGS/GENERAL

Table 82: IAX Settings/General

Bind Port

Configure the port number that the IAX2 will be allowed to listen to. The

default setting is 4569.

Bind Address

Configure the address that the IAX2 will be forced to bind to. The default

setting is 0.0.0.0, which means all addresses.

IAX1 Compatibility

Select to configure IAX1 compatibility. The default setting is "No".

No Checksums

If selected, UDP checksums will be disabled and no checksums will be

calculated/checked on systems supporting this features. The default

setting is "No".

Delay Reject

If enabled, the IAX2 will delay the rejection of calls to avoid DOS. The

default setting is "No".

ADSI

Select to enable ADSI phone compatibility. The default setting is "No".

Music On Hold Interpret

Specify which Music On Hold class this channel would like to listen to

when being put on hold. This music class is only effective if this channel

has no music class configured and the bridged channel putting the call on

hold has no "Music On Hold Suggest" setting.

Music On Hold Suggest

Specify which Music On Hold class to suggest to the bridged channel

when putting the call on hold.

Bandwidth

Configure the bandwidth for IAX settings. The default setting is "Low".

IAX SETTINGS/REGISTRATION

Table 83: IAX Settings/Registration

IAX Registration Options

Min Reg Expire

Configure the minimum period (in seconds) of registration. The default

setting is 60.

Max Reg Expire

Configure the maximum period (in seconds) of registration. The default

setting is 3600.

IAX Thread Count

Configure the number of IAX helper threads. The default setting is 10.

IAX Max Thread Count

Configure the maximum number of IAX threads allowed. The default

This manual is related to the following products: