beautypg.com

Table 46: batch add sip extension parameters – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 136

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 135 of 303

Table 46: Batch Add SIP Extension Parameters

General

Start Extension

Configure the starting extension number of the batch of extensions to be

added.

Create Number

Specify the number of extensions to be added. The default setting is 5.

Permission

Assign permission level to the user. The available permissions are

"Internal", "Local", "National" and "International" from the lowest level to

the highest level. The default setting is "Internal".

Note:

Users need to have the same level as or higher level than an outbound

rule's privilege in order to make outbound calls from this rule.

Enable Voicemail

Enable Voicemail for the user. The default setting is "Yes".

SIP/IAX Password

Configure the SIP/IAX password for the users. Three options are

available to create password for the batch of extensions.
• User Random Password.

A random secure password will be automatically generated. It is

recommended to use this password for security purpose.

• Use Extension as Password.
• Enter a password to be used on all the extensions in the batch.

Voicemail Password

Configure Voicemail password (digits only) for the users.
• User Random Password.

A random password in digits will be automatically generated. It is

recommended to use this password for security purpose.

• Use Extension as Password.
• Enter a password to be used on all the extensions in the batch.

Ring Timeout

Configure the number of seconds to ring the user before the call is

forwarded to voicemail (voicemail is enabled) or hang up (voicemail is

disabled). If not specified, the default ring timeout is 60 seconds on the

UCM6100, which can be configured in the global ring timeout setting

under web GUI->Internal Options->IVR Prompt: General Preference.

The valid range is between 5 seconds and 600 seconds.

Note:

If the end point also has a ring timeout configured, the actual ring timeout

used is the shortest time set by either device.

Auto Record

Enable automatic recording for the calls using this extension. The default

setting is disabled. The recording files can be accessed under web

GUI->CDR->Recording Files.

Skip Voicemail Password

Verification

When user dials voicemail code, the password verification IVR is skipped.

If enabled, this would allow one-button voicemail access. By default this

This manual is related to the following products: