Firmware version 1.0.2.21 – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 23
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 22 of 303
voicemail. [Table 75: UCM6100 Feature Codes]
• Added "Enforce Strong Passwords" option. [Table 76: Internal Options/General]
• Added FXS MWI Mode. [Table 79: Internal Options/Ports Config]
• Added system events with alert and Email notification support. [SYSTEM EVENTS]
• Added new web page for recording files. [RECORDING FILES]
FIRMWARE VERSION 1.0.2.21
• Added weight information. [Table 1: Technical Specifications]
• Added NTP server support. [NTP SERVER]
• Added Czech language for web GUI display. [WEB GUI LANGUAGES]
• Added VLAN support. "Layer 2 QoS 802.1Q/VLAN tag" and "Layer 2 QoS 802.1p priority value"
options for network port settings are added. [NETWORK SETTINGS]
• Updated LDAP client configurations information.
• Added sample Email settings. [EMAIL SETTINGS]
• Added manual time settings. [TIME SETTINGS]
• Added "Enable Pick Extension" and "Extension Segment" options for auto provisioning settings.
• Changed one of the discovery method from "SIP MESSAGE (OPTIONS)" to "SIP MESSAGE
(NOTIFY)" in zero-config feature.
• Added pickup group feature. [Table 75: UCM6100 Feature Codes]
• Added PSTN detection instructions for "Auto Detect" and "Semi-auto Detect". [PSTN
• Added "Auth ID" option for SIP register trunk configuration. [Table 50: Create New SIP Trunk]
• Added LDAP sync options for peer SIP trunk. [Table 50: Create New SIP Trunk]
• Changed the default setting of outbound route "Privilege Level" from "Internal" to "International" to
avoid potential misconfiguration and security risk.
• Added DISA and Fax to IVR key press event options. [Table 61: IVR Configuration Parameters]
• Added "Min Message Time" option in voicemail settings. [Table 62: Voicemail Settings]
• Added Fax setting samples. [FAX/T.38]
• Added DISA support for inbound route and IVR.
• Added Event List support to monitor local extensions and remote extensions. [BLF AND EVENT
• Added feature code *0 for "Disconnect". [Table 75: UCM6100 Feature Codes]
• Added feature code *8 for "Pickup Extension" in pickup group feature. [Table 75: UCM6100
• Added "Record Prompt" and "Custom Name of Pickup Group" options in internal options. [Table
• Added warning information for "Allow Guest Call" option to avoid potential security risk caused by
misconfiguration. [Table 82: IAX Settings/General]
• Changed reset mode to two mode "User Data" and "All". [RESET AND REBOOT]