beautypg.com

Sip settings, Sip settings/general, Table 85: sip settings/general – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 260

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 259 of 303

SIP SETTINGS

The UCM6100 SIP global settings can be accessed via Web GUI->PBX->SIP Settings.

SIP SETTINGS/GENERAL

Table 85: SIP Settings/General

Realm For Digest

Authentication

Configure the host name or domain name for the UCM6100. Realms

MUST be globally unique according to RFC3261. The default setting is

Grandstream.

Bind UDP Port

Configure the UDP port used for SIP. The default setting is 5060.

Bind IP Address

Configure the IP address to bind to. The default setting is 0.0.0.0, which

means binding to all addresses.

Allow Guest Calls

If enabled, the UCM6100 allows unauthorized INVITE coming into the

PBX and the call can be made. The default setting is "No".

Warning:

Please be aware of the potential security risk when enabling "Allow Guest

Calls" as this will allow any user with the UCM6100 address to dial into

the UCM6100.

Overlap Dialing

Select to enable overlap dialing support. The default setting is "No".

Allow Transfer

If set to "No", all transfers initiated by the endpoint in the UCM6100 will be

disabled (unless enabled in peers or users). The default setting is "Yes".

Enable DNS SRV Lookups on

Outbound Calls

Select to enables DNS SRV lookups on outbound calls from the

UCM6100. The default setting is "Yes".

MWI From

When sending MWI NOTIFY requests, this value will be used in the

"From:" header as the "name" field. If no "From User" is configured, the

"user" field of the URI in the "From:" header will be filled with this value.

SIP Domain Support

Domain

Configure the domain for the UCM6100. Incoming INVITE and REFER

messages can be matched against a list of "allowed" domains, each of

which can direct the call to a specific context if desired. By default, all

domains are accepted and sent to the default context or the context

associated with the user/peer placing the call. Register to non-local

domains will be automatically denied if a domain list is configured. Up to

10 domains can be added.

From Domain

Configure the domain in the "From:" header of the SIP message. It may

This manual is related to the following products: