Grandstream UCM6100 User Manual for 1.0.9.25 - Manual (Page 210)

Firmware Version 1.0.9.25 UCM6100 Series IP PBX User Manual Page 209 of 303
PICKUP GROUPS
The UCM6100 supports pickup group feature which allows users to pick up incoming calls for other
extensions if they are in the same pickup group, by dialing "Pickup Extension" feature code (by default *8).
CONFIGURE PICKUP GROUPS
Pickup groups can be configured via Web GUI->PBX->Call Features->Pickup Groups.
• Click on "Create New Pickup Group" to create a new pickup group.
• Click on
to edit the pickup group.
Select extensions from the list on the left side to the right side.
Figure 122: Edit Pickup Group
• Click on
to delete the pickup group.
CONFIGURE PICKUP FEATURE CODE
When picking up the call for the pickup group member, the user only needs to dial the pickup feature code.
It’s not necessary to add the extension number after the pickup feature code. The pickup feature code is
configurable under Web GUI->PBX->Internal Options->Feature Codes.
The default pickup feature code is *8.