beautypg.com

Iax settings/static defense, Table 84: iax settings/static defense – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 259

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 258 of 303

setting is 100.

Auto Kill

If set to "yes", the connection will be terminated if ACK for the NEW

message is not received within 2000ms. Users could also specify number

(in milliseconds) in addition to "yes" and "no". The default setting is "yes".

Authentication Debugging

If enabled, authentication traffic in debugging will not show. The default

setting is "No".

Codec Priority

Configure codec negotiation priority. The default setting is "Reqonly".
• Caller

Consider the callers preferred order ahead of the host's.

• Host

Consider the host's preferred order ahead of the caller's.

• Disabled

Disable the consideration of codec preference all together.

• Reqonly

This is almost the same as "Disabled", except when the requested

format is not available. The call will only be accepted if the requested

format is available.

Type of Service

Configure ToS bit for preferred IP routing.

IAX Trunk Options

Trunk Frequency

Configure the frequency of trunk frames (in milliseconds). The default

setting is 20.

Trunk Time Stamps

If enabled, time stamps will be attached to trunk frames. The default

setting is "No".

IAX SETTINGS/STATIC DEFENSE

Table 84: IAX Settings/Static Defense

Call Token Optional

Enter a single IP address (e.g., 11.11.11.11) or a range of IP addresses

(11.11.11.11/22.22.22.22) for which call token validation is not required.

Max Call Numbers

Configure the maximum number of calls allowed for a single IP address.

Max Unvalidated Call Numbers Configure the maximum number of unvalidated calls for all IP addresses.

Call Number Limits

Configure to limit the number of calls for a give IP address of IP range.

IP or IP Range

Enter the IP address (11.11.11.11) or a range of IP addresses

(11.11.11.11/22.22.22.22) to be considered for call number limits.

This manual is related to the following products: