Grandstream UCM6100 User Manual for 1.0.9.25 - Manual (Page 247)

Firmware Version 1.0.9.25 UCM6100 Series IP PBX User Manual Page 246 of 303
Blacklist Remove
• Default Code: *41.
• To remove a number from current blacklist for inbound route,
dial *41 and follow the voice prompt to remove the number.
Call Pickup on Ringing
• Default Code: **.
• To pick up a call for any extension xxxx, enter the code followed
by the extension number xxxx.
Pickup Extension
• Default Code: *8.
• This code is for the pickup group which can be assigned for
each extension on the extension configuration page.
• If there is an incoming call to an extension, the other
extensions within the same pickup group can dial *8 directly to
pick up the call.
Direct Dial Voicemail Prefix
• Default Code: *
• This code is for the user to directly dial or transfer to an
extension's voicemail.
• For example, directly dial *5000 will have to call go into the
extension 5000's voicemail. If the user would like to transfer the
call to the extension 5000's voicemail, enter *5000 as the
transfer target number.
Call Completion Request
• Default Code: *11
• This code is for the user who wants to use Call Completion to
complete a call.
Call Completion Cancel
• Default Code: *12
• This code is for the user who wants to cancel Call Completion
request.
Enable Spy Check this box to enable spy feature codes.
Listen Spy
This is the feature code to listen in on a call to monitor
performance. Monitor’s line will be muted, and neither party will
hear from the monitor’s extension. The default setting is *54.
Whisper Spy
This is the feature code to speak to one side of the call (for
example, whisper to employees to help them handle a call).
Only one side will be able to hear from the monitor’s extension.
The default setting is *55.