Grandstream UCM6100 User Manual for 1.0.9.25 - Manual (Page 166)

Firmware Version 1.0.9.25 UCM6100 Series IP PBX User Manual Page 165 of 303
SLA STATION
Starting from 1.0.7.10, the UCM6100 supports SLA that allows mapping the key with LED on a multi-line
phone to different external lines. When there is an incoming call and the phone starts to ring, the LED on
the key will flash in red and the call can be picked up by pressing this key. This allows users to know if the
line is occupied or not. The SLA function on the UCM6100 is similar to BLF but SLA is used to monitor
external line i.e., analog trunk on the UCM6100. Users could configure the phone with BLF mode on the
MPK to monitor the analog trunk status or press the line key pick up call from the analog trunk on the
UCM6100.
CREATE/EDIT SLA STATION
SLA Station can be configured on web GUI->PBX->Basic/Call Routes->SLA Station.
Figure 93: SLA Station
• Click on “Create New SLA Station” to add a SLA Station.
• Click on
to edit the SLA Station. The following table shows the SLA Station configuration
parameters.
• Click on
to delete the SLA Station.
Table 56: SLA Station Configuration Parameters
Station Name Configure a name to identify the SLA Station.
Station Specify a SIP extension as a station that will be using SLA.
Available SLA Trunks Existing Analog Trunks with SLA Mode enabled will be listed here.
Selected SLA Trunks
Select a trunk for this SLA from the Available SLA Trunks list. Click on
to arrange the order. If there are multiple trunks selected, when
there are calls on those trunks at the same time, pressing the LINE key on
the phone will pick up the call on the first trunk here.