Grandstream UCM6100 User Manual for 1.0.9.25 - Manual (Page 128)

Firmware Version 1.0.9.25 UCM6100 Series IP PBX User Manual Page 127 of 303
Table 39: IAX Extension Configuration Parameters - Media
SIP Settings
Max Number of Calls
Configure the maximum number of calls allowed for each remote IP
address.
Require Call Token
Configure to enable/disable requiring call token. If set to "Auto", it might
lock out users who depend on backward compatibility when peer
authentication credentials are shared between physical endpoints. The
default setting is "Yes".
SRTP Enable SRTP for the call. The default setting is disabled.
Fax Mode
Select Fax Mode. The default setting is “None”.
• None: Disable Fax. This is the default setting.
• Fax Detect: Fax signal from the user/trunk during the call can be
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI->PBX->Internal Options->Fax/T.38.
Strategy
This option controls how the extension can be used on devices within
different types of network.
• Allow All
Device in any network can register this extension.
• Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
• A Specific IP Address
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
Codec Preference
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G,726, G.722, G.729, G.723, ILBC,
ADPCM, H.264, H.263 and H.263p.
Table 40: IAX Extension Configuration Parameters - Features
Call Transfer
Call Forward Unconditional
Configure the Call Forward Unconditional target number. If not
configured, the Call Forward Unconditional feature is deactivated. The
default setting is deactivated.
CFU Time Condition
Select time condition for Call Forward Unconditional. CFU takes effect
only during the selected time condition. The available time condition are
“Office Time”, “Out of Office Time”, “Holiday”, “Out of Holiday”, “Out of
Office Time or Holiday” and “Specific”.