Model configuration, Model templates, Table 33: create new model template – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 105
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 104 of 303
• Click on “Toggle Selected Template(s)” to toggle the status between enabled/disabled for the selected
templates.
MODEL CONFIGURATION
MODEL TEMPLATES
Model layer configuration allows users to apply model-specific configurations to different devices. Users
could create/edit/delete a model template by accessing web GUI, page PBX->Zero Config->Model
Templates. If multiple model templates are created and enabled, when the user configures the device in
Edit Device dialog->Advanced Settings, the user can select to use one of the model template for the
device. Please refer to section
for more details on using the model template.
For each created model template, users can assign it as default model template. If assigned as default
model template, the values in this model template will be applied to all the devices of this model. There is
always only one default model template that can be assigned at one time on the UCM6100.
The selected model template and the default model template will both take effect when generating the
config file for the device. However the model template has higher priority to default model template when it
comes to the same setting option/field. If the same option/field has different value configured in the default
model template and the selected model template, the value for this option/field in the selected model
template will override the value in default model template.
• Click on “Create New Template” to add a model template.
Table 33: Create New Model Template
Model
Select a model to apply this template. The supported Grandstream
models are listed in the dropdown list for selection.
Template Name
Create a name for the model template.
Description
Enter a description for the model template. This is optional.
Default Model Template
Select to assign this model template as the default model template. The
value of the option in default model template will be overridden if other
selected model template has a different value for the same option.
Active
Check this option to enable the model template.
• Click on
to edit the model template.