beautypg.com

Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 246

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 245 of 303

Feature Code Digits Timeout

• Default Setting: 1000.
• Configure the maximum interval (in milliseconds) between the

digits input to activate the feature code.

Call Park

• Default Extension: 700.
• During an active call, initiate blind transfer and then enter this

code to park the call.

Parked Lots

• Default Extension: 701-720.
• These are the extensions where the calls will be parked, i.e.,

parking lots that the parked calls can be retrieved.

Parking Timeout (s)

• Default setting: 300.
• This is the timeout allowed for a call to be parked. After the

timeout, if the call is not picked up, the extension who parks the

call will be called back.

Feature Codes

Voicemail Access Code

• Default Code: *98.
• Enter *98 and follow the voice prompt. Or dial *98 followed by

the extension and # to access the entered extension's

voicemail box.

My Voicemail

• Default Code: *97.
• Press *97 to access the voicemail box.

Agent Pause

• Default Code: *83.
• Pause the agent in all call queues.

Agent Unpause

• Default Code: *84.
• Unpause the agent in all call queues.

Paging Prefix

• Default Code: *81.
• To page an extension, enter the code followed by the extension

number.

Intercom Prefix

• Default Code: *80.
• To intercom an extension, enter the code followed by the

extension number.

Blacklist Add

• Default Code: *40.
• To add a number to blacklist for inbound route, dial *40 and

follow the voice prompt to enter the number.

This manual is related to the following products: