beautypg.com

Call park, Park a call, Retrieve the parked call – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 249: Enable spy

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 248 of 303

Figure 144: Download Recording File from Recording Files Page

CALL PARK

The UCM6100 provides call park and call pickup features via feature code.

PARK A CALL

There are two feature codes that can be used to park the call.


• Feature Maps->Call Park (Default code #72)

During an active call, press #72 and the call will be parked. Parking lot number (default range 701 to

720) will be announced after parking the call.


• Feature Misc->Call Park (Default code 700)

During an active call, initiate blind transfer (default code #1) and then dial 700 to park the call. Parking

lot number (default range 701 to 720) will be announced after parking the call.

RETRIEVE THE PARKED CALL

To retrieve the parked call, simply dial the parking lot number and the call will be established. If a parked

call is not retrieved after the timeout, the original extension who parks the call will be called back.

ENABLE SPY

If “Enable Spy” option is enabled, feature codes for Listen Spy, Whisper Spy and Barge Spy are available

for users to dial from any extension to perform the corresponding actions.

Assume a call is on-going between extension A and extension B, user could dial the feature code from

extension C to listen on their call (*54 by default), whisper to one side (*55 by default), or barge into the call

This manual is related to the following products: