Table 17: firewall rule settings, Figure 34: create new firewall rule – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 69
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 68 of 303
• Action: "Accept"
• Type "In"
• Destination port is set to the system login port (e.g., by default 8089)
• Protocol is not UDP
Figure 34: Create New Firewall Rule
Table 17: Firewall Rule Settings
Rule Name
Specify the Firewall rule name to identify the firewall rule.
Action
Select the action for the Firewall to perform.
• ACCEPT
• REJECT
• DROP
Type
Select the traffic type.
• IN
If selected, users will need specify the network interface "LAN" or "WAN"
(for UCM6102 only) for the incoming traffic.
• OUT
Service
Select the service type.
• FTP
• SSH
• Telnet
• TFTP
• HTTP
• LDAP
• Custom
If "Custom" is selected, users will need specify Source (IP and port),
Destination (IP and port) and Protocol (TCP, UDP or Both) for the service.
Please note if the source or the destination field is left blank, it will be used
as "Anywhere".