Table 51: sip register, Trunk configuration parameters, Table 51: sip register trunk – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 154: Configuration parameters, Table 51, Sip register trunk configuration parameters

Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 153 of 303
set to "User=Phone". Then a "User=Phone" parameter will be attached to
the Request-Line and TO header in the SIP request to indicate the E.164
number. If set to "Enable", "Tel:" will be used instead of "SIP:" in the SIP
request. The default setting is disabled.
Need Registration
Select whether the trunk needs to register on the external server or not
when "Register SIP Trunk" type is selected. The default setting is No.
Username
Enter the username to register to the trunk from the provider when
"Register SIP Trunk" type is selected.
Password
Enter the password to register to the trunk from the provider when
"Register SIP Trunk" is selected.
Auth ID
Enter the Authentication ID for "Register SIP Trunk" type.
Auto Record
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files can be accessed
under web GUI->CDR->Recording Files.
Table 51: SIP Register Trunk Configuration Parameters
Basic Settings
Provider Name
Configure a unique label to identify this trunk when listed in outbound
rules, inbound rules and etc.
Host Name
Configure the IP address or URL for the VoIP provider’s server of the
trunk.
Transport
Configure the SIP transport protocol to be used in this trunk. The default
setting is "All - UDP Primary".
• UDP Only
• TCP Only
• TLS Only
• All - UDP Primary: UDP is the primary transport protocol when all the
other SIP transport methods are available too.
• All - TCP Primary: TCP is the primary transport protocol when all the
other SIP transport methods are available too.
• All – TLS Primary: TLS is the primary transport protocol when all the
other SIP transport methods are available too.
Keep Original CID
Keep the CID from the inbound call when dialing out. This setting will
override “Keep Trunk CID” option. Please make sure that the peer PBX at
the other side supports to match user entry using “username” field from
authentication line.
Keep Trunk CID
If enabled, the trunk CID will not be overridden by extension’s CID when
the extension has CID configured. The default setting is “No”.