beautypg.com

Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 171

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 170 of 303

route.

Maximum Call Duration

Configure the maximum duration of the call (in seconds). The default

setting is 0, which means no limite.

Warning Time

Configure the warning time for the call using this outbound route. If set to

x seconds, the warning tone will be played to the caller when x seconds

are left to end the call.

Warning Repeat Interval

Configure the warning repeat interval for the call using this outbound

route. If set to x seconds, the warning tone will be played every x seconds

after the first warning.

Privilege Level

Select privilege level for the outbound rule.
• Internal: The lowest level required. All users can use this rule.
• Local: Users with Local, National, or International level are allowed to

use this rule.

• National: Users with National or International level are allowed to use

this rule.

• International: The highest level required. Only users with international

level can use this rule.

• Disable: The default setting is "Disable". If selected, only the matched

source caller ID will be allowed to use this outbound route.

Please be aware of the potential security risks when using "Internal" level,

which means all users can use this outbound rule to dial out from the

trunk.

Enable Filter on Source Caller

ID

When enabled, users could specify extensions allowed to use this

outbound route. "Privilege Level" is automatically disabled if using

"Enable Filter on Source Caller ID".

The following two methods can be used at the same time to define the

extensions as the source caller ID.

1. Select available extensions/extension groups from the left to the right.

This allows users to specify arbitrary single extensions available in

the PBX.

2. Custom Dynamic Route: define the pattern for the source caller ID.

This allows users to define extension range instead of selecting them

one by one.
• All patterns are prefixed with the "_".
• Special characters:

X: Any Digit from 0-9.

Z: Any Digit from 1-9.

N: Any Digit from 2-9.

This manual is related to the following products: