beautypg.com

Inbound rule configurations, Table 58: inbound rule configuration parameters, Table 58: inbound rule configuration – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual

Page 173: Parameters, Table 58: inbound rule, Configuration parameters

background image

Firmware Version 1.0.9.25

UCM6100 Series IP PBX User Manual

Page 172 of 303

• Click on "Blacklist" to configure blacklist for all inbound routes.

• Click on

to edit the inbound route.

• Click on

to delete the inbound route.

INBOUND RULE CONFIGURATIONS

Table 58: Inbound Rule Configuration Parameters

Trunks

Select the trunk to configure the inbound rule.

DID Pattern

• All patterns are prefixed with the "_".
• Special characters:

X: Any Digit from 0-9.

Z: Any Digit from 1-9.

N: Any Digit from 2-9.

".": Wildcard. Match one or more characters.

"!": Wildcard. Match zero or more characters immediately.

Example: [12345-9] - Any digit from 1 to 9.

• The pattern can be composed of two parts, divided by a ‘/’ character.

The first part is used to specify the dialed number the second part is

used to specify the caller ID and it is optional, if set it means only the

extension with the specific caller ID is allowed to call in or call out.

For example, patter '_2XXX/1234' means the only extension with the

caller ID '1234' is allowed to use this rule.

Privilege Level

Configure the privilege level for this inbound route.

Default Destination

Select the default destination for the inbound call.
• Extension
• Voicemail
• Conference Room
• Queue
• Ring Group
• Paging/Intercom
• Voicemail Group
• Fax
• DISA
• IVR
• Dial By Name
• External Number
• By DID

When "By DID" is used, the UCM6100 will look for the destination

This manual is related to the following products: