Reset and reboot, Syslog, Figure 183: reset and reboot – Grandstream UCM6100 User Manual for 1.0.9.25 User Manual
Page 297
Firmware Version 1.0.9.25
UCM6100 Series IP PBX User Manual
Page 296 of 303
All the cleaner logs will be listed on the bottom of the page.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
Cleaner will delete data based on Recording Storage selection. If USB Disk is selected, Cleaner will only
clean data in USB and local data will leave untouched. If Enable auto change is selected and USB disk is
connected, Cleaner will only delete data in USB drive. Recordings Storage function can be found under
web UI-> Settings-> Recordings Storage-> Recordings Storage.
--------------------------------------------------------------------------------------------------------------------------------------------
RESET AND REBOOT
Users could perform reset and reboot under Web GUI->Maintenance->Reset and Reboot.
To factory reset the device, select the mode type first. There are two different types for reset.
•
User Data: All the data including voicemail, recordings, IVR Prompt, Music on Hold, CDR and backup
files will be cleared.
•
All: All the configurations and data will be reset to factory default.
Figure 183: Reset and Reboot
SYSLOG
On the UCM6100, users could dump the syslog information to a remote server under Web
GUI->Maintenance->Syslog. Enter the syslog server hostname or IP address and select the module/level
for the syslog information.